PZ Probe
E3D

PZ Probe

Contender Piezo nozzle-contact probe with excellent repeatability; fiddly tuning keeps it a niche pick
USD $46.74

Where to buy (1)

Listed at ~$47 USD. Vendors set their own prices.

E3D Online (opens in a new tab)

Full Specifications

Type Nozzle Contact
Repeatability 0.1µm std dev; 6µm range over 100 probes (E3D test)
Installation Complexity Hard

Pros & Cons

Pros
  • Nozzle itself is the probe — zero XY offset and no Z-offset recalibration after a nozzle change
  • Excellent repeatability in E3D's testing: 0.1µm std dev over 100 probes, 15,000-cycle durability test
  • Works with any bed surface (contact sensing, no conductivity requirement)
  • Lightweight, compact washer + board; adds little toolhead mass vs Voron Tap
  • Configurable via UART/I2C with 5 presets, threshold and IIR filter tuning
  • Klipper and Duet support; usable as X, Y or Z probe or for tool-offset measurement on a tool changer
Cons
  • Not plug-and-play — requires sensitivity/preset tuning and can suffer false triggering or no triggering (motor vibration, fan/heater noise, probing speed, plastic on the nozzle)
  • Strict 5V maximum; exceeding it can cause serious damage, and bed damage during probing is not covered under warranty
  • Cannot be integrated into a standard Revo Voron sink — Voron users need the separate Coldside kit
  • Washer needs precise ~1Nm preload torque and hard, smooth mating surfaces; a loose screw causes inconsistent probing
  • Nozzle must be clean and probed ~50°C below print temperature to avoid oozing-related mis-triggers
  • Currently sold out on E3D Online (product page shows 'Sold out')

Where to Buy