Voron Tap
Voron Design

Voron Tap

Contender Accurate nozzle-touch Z; installation complexity has pushed most new Voron builders to Beacon
USD $19.99

Where to buy (1)

Listed at ~$20 USD. Vendors set their own prices.

Fabreeko (opens in a new tab)

Full Specifications

Type Contact
Repeatability Direct nozzle-touch; repeatability not published; community-measured ~1-5µm std dev typical
Klipper Native Yes
Installation Complexity Hard
Open Source Yes

Pros & Cons

Pros
  • Direct nozzle contact = zero probe offset from nozzle tip; works with any bed surface (textured PEI, smooth, magnetic sheets); fully integrated into Stealthburner/CW2 toolhead; open source Voron project; r2 revision resolved documented r1 PCB reliability issues; no separate probe dock required
Cons
  • Requires Stealthburner toolhead — not compatible with other toolhead designs (Xol, Dragon Burner, etc.); installation involves precise spring tensioning and gantry configuration; nozzle thermal expansion causes Z reading drift unless compensated; r1 PCBs had documented optical sensor failures; slower bed mesh than eddy probes (sequential point-by-point); cumulative nozzle wear from repeated touch cycles

Where to Buy