FluxHeat V6 ALPS Nozzle Probe
Mellow 3D

FluxHeat V6 ALPS Nozzle Probe

Contender High-flow V6 hotend with nozzle-touch leveling built in; promising but new and unproven at scale.
USD $62.4

Where to buy (1)

Listed at ~$62 USD. Vendors set their own prices.

3D Mellow (opens in a new tab)

Full Specifications

Type Nozzle Contact
Repeatability Unknown
Klipper Native Yes
Installation Complexity Medium

Pros & Cons

Pros
  • Hotend and probe in one purchase ($62.40) — replaces a BLTouch/3D Touch and a hotend at the same time
  • High-performance hotend: 96W ceramic heater, up to 350 C with PT1000 sensor, over 40 mm3/s flow, TC4 titanium heat break
  • Direct nozzle-touch leveling via the integrated ADS131M02 ALPS module (24-bit ADC, 64 kHz sampling, 128x gain, Kalman filtering) — no Z-offset recalibration after nozzle changes
  • USB plug-and-play threshold tuning on a PC, no coding or firmware tweaks required
  • Standard V6 nozzle compatibility (copper, hardened steel, tungsten carbide, silicon carbide) and Klipper/Marlin/RRF support
  • 5.0 rating from 15 reviews on Mellow's own store page
Cons
  • ALPS pressure accuracy/repeatability is not published (Accuracy field is 'Unknown') — no independent verification of the leveling precision
  • Not suitable for easily deformable heated beds or X-axes prone to deformation/distortion, per Mellow's own manual
  • New integrated product with a small community footprint; far less field-proven than Beacon, Cartographer or Voron Tap
  • Bigger install than a probe alone — a full hotend swap plus ALPS wiring (1.5 m cable to mainboard UART) and threshold calibration
  • Listing also sells 2.85 mm-oriented variants/sets, so buyers must pick the right filament-diameter set

Where to Buy