High Impact Polystyrene

HIPS

SITUATIONAL Support material for ABS, or standalone budget part

HIPS dissolves in limonene, making it an ABS-compatible soluble support material. It can also be used as a standalone material — similar print settings to ABS with slightly better impact resistance. Mostly relevant as an ABS support solution or for large-format budget structural parts.

Print Settings
Nozzle Temp 220–240°C
Bed Temp 90–110°C
Chamber 45–55°C recommended
Cooling Fan 0–20%
Max Speed 80 mm/s
Heat Deflection ~95°C
Difficulty Intermediate
Updated 2026-05-31
At a glance
Pros
  • Dissolves in d-Limonene — compatible ABS support material
  • Better impact resistance than ABS in standalone use
  • Lower cost than ABS in most markets
  • Can be sanded, primed, and painted cleanly
Cons
  • Requires d-Limonene for dissolution — not as accessible as water (PVA)
  • Enclosure required for reliable results
  • Fumes similar to ABS — ventilation necessary
  • Largely superseded by ASA for standalone structural use
Overview

HIPS has two distinct use cases and they’re not equally compelling. As a support material for ABS, it’s the original soluble support: prints at near-identical temperatures to ABS, dissolves in d-Limonene, and leaves clean interfaces. If you’re running a dual-extrusion machine printing ABS, HIPS as the support material is the correct setup.

As a standalone material, the case is weaker. HIPS prints slightly easier than ABS with marginally better impact resistance, but it’s being pushed out of the market by ASA, which offers better UV stability and similar ease for outdoor use, and by PETG, which is easier to print without an enclosure for indoor applications. HIPS made more sense when ABS was the default engineering material. The current landscape has better options for most use cases.

The enclosure requirement is the same as ABS. Cold chamber means warping. HIPS also benefits from a brim on large flat parts, garolite bed surface for serious adhesion, and proper fume ventilation; the fumes profile is essentially the same as ABS. If you’re already set up for ABS, HIPS adds zero new infrastructure requirements. If you aren’t set up for ABS, HIPS doesn’t simplify the setup enough to justify it.

Brand Recommendations
Polymaker PolyLite HIPS TOP
$19.99/kg

Most consistent HIPS on the market. Low warp, good surface finish.

Hatchbox HIPS MID
$21.99/kg

Reliable and widely available. Good for first HIPS attempts.

SUNLU HIPS BUDGET
$14.99/kg

Works but warps more than premium options. Fine for support material where surface quality doesn't matter.

Troubleshooting
Warping
Cause Cold chamber allows shrinkage stresses to delaminate layers
Fix Sealed enclosure at 50°C minimum. Same fixes as ABS — garolite or PEI bed, large brim.
Poor limonene dissolution
Cause Incorrect solvent concentration or temperature
Fix Pure d-Limonene at room temperature. Replace when saturated — HIPS dissolves slower than PVA in water.
Layer cracking
Cause Cold ambient temperature or draft during print
Fix Seal enclosure completely. Zero fan. Preheat chamber before starting print.
Printer Compatibility
Printer Rating Notes
Voron 2.4 EXCELLENT Enclosed chamber. Same setup as ABS — identical temperature requirements.
Bambu X1C / P1S GOOD AMS compatible. Use ABS profile as starting point.
Prusa MK4 POOR Open frame. Enclosure mod required for reliable results.
Bambu A1 / A1 Mini NOT RECOMMENDED No enclosure — HIPS requires chamber heat.