Home / Tools/ Pressure Advance

Pressure Advance Calibration

Generate a corner-test G-code pattern for Klipper (PA), Marlin (LA/K), RepRapFirmware, or Bambu. Configure your printer, download the file, and read the cleanest corner.

Patterns 17
PA Range 0.000 → 0.080
Est. Print Time ~8 min
Firmware Klipper
Updating…
 

How to use

  1. Configure your printer settings in the panel. Select a preset to auto-fill common values.
  2. Download or copy the G-code file. Do not slice it — print it directly from your host (Mainsail, Fluidd, OctoPrint, or SD card).
  3. Print it. Each column of corners corresponds to one PA value, printed left to right in ascending order. Your display will show the current PA value during printing.
  4. Find the cleanest column — the one with the sharpest corners and no bulging or gaps. Count from left: PA = start + (column_index × increment).
Reading the test pattern
  Too low (PA=0)      Correct           Too high
  ┌──────┐           ┌──────┐           ┌──────┐
  │  ╔══╗│           │  ┌──┐│           │  ╔══╗│
  │◀▶║  ║│           │  │  ││           │◀▶║  ║│
  │  ╚══╝│ ← bulge   │  └──┘│ ← clean  │  ╚══╝│ ← ringing
  └──────┘ at corner └──────┘ 90° walls └──────┘ overshoot
Klipper: set pressure_advance: in your printer.cfg extruder section.
Marlin: set DEFAULT_LINEAR_ADVANCE_K in Configuration_adv.h or send M900 K[value] and M500 to save.
Bambu users: M900 support varies by firmware version. If this doesn't work, use Bambu Studio's built-in Calibration → Pressure Advance tool instead.

Full pressure advance tuning guide → (covers interpreting results, corner analysis, and applying your value)