Full Specifications

Type Print-it-yourself
Part Cooling Fans CPAP (7040), 5015
Compatible Printers Voron V0.1, Printers for Ants

Pros & Cons

Pros
  • CPAP blower delivers high CFM and very high static pressure — stronger part cooling than blower fans
  • Shutter switches between internal (closed-loop, ABS) and external (PLA/PETG) air intake
  • Backup 5015 Mailbox duct swaps in without dismantling the toolhead
  • No loss in X or Z travel, at most 3mm in Y
  • Wide extruder and hotend support
Cons
  • Requires Wonsmart WS7040 fan + driver board + Klipper Expander (or logic-level control) — extra cost and wiring
  • Fan can pull 2.8A at full load — needs a suitable MOSFET, not a standard MCU fan header
  • CPAP hose routing is tight on the v0.1
  • Hotend can struggle to hold temp at high fan output — may need PID tuning or a stronger heater

Source files

GitHubchirpy2605/voronCommunity project: BOM, print files and build docs.(opens in a new tab)